If you happen to face this error message "Copying pre-existing data completed with error, For additional details, go to initial sync details tab" while starting the dual-write entity map then please check you have setup the cross company data sharing policy for the underline table of the entity map (which is a data entity in D365 FO).
To resolve this issue, Go to System Administration | Setup | Configure cross=company data sharing screen and look for policy where you may have setup the underline table of the data entity used for dual-write entity map. Disable the policy and then run the dual-write job again, wait until it turns to running state. Enable the cross-company data sharing policy again choose No on the next open pop-up window otherwise it will run against all data across all legal entitles which might not be necessary for this exercise as you just disabled it to start dual-write entity map.
Thanks for giving the information. This blog is very helpful. I learned a lot from this I hope you will keep sharing such information in the future also.
ReplyDeletevisit site
Thanks for giving the information. This blog is very helpful. I learned a lot from this I hope you will keep sharing such information in the future also.
ReplyDeleteOutlook bellen
for warning : Warning:[DWCE0001] Export was skipped. Max lookup count supported in Initial Sync stage is 10. Current lookup count 11
ReplyDeletehttps://blog.johanpersson.nu/?p=4989
I couldn't able to find policy for cross company data sharing, but followed blog for some error we are getting https://blog.johanpersson.nu/?p=4989
ReplyDeleteWarning:[DWCE0001] Export was skipped. Max lookup count supported in Initial Sync stage is 10. Current lookup count 11
Excellent post. I am also experiencing a few of these issues as well, christmas goldie hawn red jacket but now I have got some ideas.
ReplyDelete